relocating a hkc alarm

[norriszxr]

i was wondering if anyone could help.

i recently moved shops and when leaving my old shop i removed the alarm so i could use it in my new premises as the alrm company at the time were not that pushed in coming out and doing it for me.

is there a way that you can do a full reset and start from the beginning. i have purchased the online manual here but there is a lot to it and getting a bit lost. what i have hooked up at the moment is two door sensors, two PIR and a glass break sensor.

thanks

[Admin]

It all dependes on whether the alarm system is engineer locked. Power down the control panel by disconnecting the mains power & also the back up battery.
Locate the factory link on the main PCB (marked LK1) & remove this.
Power up the system & disarm using the factory code 1111.
If the system disarms you have sucessfully unlocked the panel & can now enter the engineer mode using the code 1278.(Don't forget to replace the factory link at this stage.) All codes & configurations can be set in this mode.