aritech cs350

[curt43]

My Keypad Is Not Working, And Power Indicator Light Is
Not On.
I Have Power Going To My Main Control Box And
Checked Fuses All Seems Ok.
All Was Working Ok Until I Switched Power Off To Change
Low Battery In Which I Taken Out And Left Out A Few
Days Earlier To Obtain New One.

Can Anybody Help.

Curt43

[k1]

check if you are getting 12 volts dc at. A B. Terminals at the keypad.

[curt43]

hi
I have checked keypad feed A B terminals as you said and have 12.9v
at them.when conected together through my voltmeter.
I have removed battery from my bell/siren box to stop alarm sounding
not sure if this will effect keypad not working.
i noticed spare resister type wires celotaped to the back of my
control box,any idea why this is.
I may need to purchase manual for this system,would you no
cost please.
Any other reason why keypad not working would be greatly
appreciated.

curt 43

[Admin]

If you have 12v dc on A & B & there is no display then the keypad is probobly faulty. To eliminate a problem with the cable remove the kepad bring it up to the control panel & wire it directly on a short lenght of cable. (bear in mind this could still be a fault with the panel also) Removing the battery from the bell wont affect the operation of the keypad.
The spare resistors are for zone wiring & external bell tamper only.

[curt43]

hi colm
Any idea where i can get replacement control and keypad panels
for this system,and approx cost.

thanks

[Admin]

Where are you living? In dublin try
Reliable Security Products (http://www.rspl.ie/reliablesecurity/Main/Home.htm)
Greenhills Rainbow (http://www.grdcctv.ie/about/)

Cost between €50- €80